Topic: ithaca 37 |
anderrl
Replies: 6
Views: 9064 |
Forum: 16ga. Guns
Posted: Sun Jul 17, 2005 10:53 pm Subject: ithaca 37 |
it could be a while before i get to even look it over! i'm in buffalo ny. right now, and project is home in tx. |
Topic: ithaca 37 |
anderrl
Replies: 6
Views: 9064 |
Forum: 16ga. Guns
Posted: Thu Jul 14, 2005 8:50 pm Subject: ithaca 37 |
thank you so mutch for this vital information! it is the same no. of threads per inch. so it must be the 55deg. i will follow your instructions to the letter! and i know how hard it is picking up the ... |
Topic: ithaca 37 |
anderrl
Replies: 6
Views: 9064 |
Forum: 16ga. Guns
Posted: Wed Jul 13, 2005 9:50 pm Subject: ithaca 37 |
old barrel was crunched, i've checked the threads and they appear identicle! but i will check closer, because 5 degs is small. |
Topic: Lengthing the Chamber |
anderrl
Replies: 6
Views: 10815 |
Forum: 16ga. Guns
Posted: Wed Jul 13, 2005 9:17 pm Subject: Lengthing the Chamber |
i have done this quite a few times and have had good success! you will have to take it to a very qualified gunsmith(not a parts changer) to determine if this is prudent in your specific gun! |
Topic: 16 GA Drilling |
anderrl
Replies: 2
Views: 6574 |
Forum: 16ga. Guns
Posted: Wed Jul 13, 2005 9:09 pm Subject: 16 GA Drilling |
the only sure way is to make a chamber cast and take detailed measurements to compare in cartridges of the world! be advised, that a lot of these have been rechambered to try and use ammo that was ava ... |
Topic: ithaca 37 |
anderrl
Replies: 6
Views: 9064 |
Forum: 16ga. Guns
Posted: Sat Jul 09, 2005 8:18 am Subject: ithaca 37 |
help please! does anyone out there know how to alter new style barrels to fit pre-855000 s/n receivers! i have; lathes and a mill! and know how to use them. but i haven't had any luck finding any inf ... |