I've been loading Fiocci 67mm hulls with no issues on my MEC JR, but I'm going to move down to 2 1/2" and it appears that I will not ba able to get good crimps. I'm not that interested in roll crimping so I'm looking at buying the MEC short shell kit.
Their adds say its fing for either 12 or 20 ga, and they fail to mention 16....typical. Has anyone used it? Is it ok for 16's Is there another solution that I should consider?
Joined: 16 Jan 2006
Location: Sandy Lake, PA
My VersaMec has different height attachment points where the mast mounts onto the base. I just put the screw in the next higher hole when going to 3" from 2 3/4" 12 ga. hulls. Not the same with the 600 Jr?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum