Author |
Message |
< 16ga. General Discussion ~ New Sweet Sixteen Stock Split |
|
Posted:
Wed May 24, 2017 3:18 pm
|
|
|
Joined: 05 Oct 2015
Posts: 17
Location: Western PA
|
|
Good news! Almost three months to the day, I received a replacement for my A5 with the cracked stock. My dealer called and said that Browning set me a new gun. So now I will have it for the Ruffed Grouse Shoot at Castlewood Clays on June 24th. Keep in mind it was at a ruffed grouse shoot in February that it cracked. Maybe I will go shoot a round or two before then. |
_________________ It is all about Black Labs, Birds, and good friends to share the day with. |
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Thu May 25, 2017 7:18 am
|
|
|
Joined: 08 Dec 2010
Posts: 32
Location: East TN
|
|
I have not been able to shoot my SWT yet. The fore end was split or split when I put the gun together. It has been at Browning for a month.
Interestingly, I called about the repair this week. Browning was very apologetic as you would imagine.
I was told Browning sent an employee to Spain to oversee the replacement of the fore ends. My stock is one of many.
I also think the person who went to Spain has an engineering background (as one might expect. |
|
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Sat Sep 23, 2017 12:39 pm
|
|
|
Joined: 20 Sep 2017
Posts: 1
|
|
I purchased a new Sweet 16 last month and took it out for a few rounds of clays. When I got it home I took it out of the case to see the stock was split on both sides back from the receiver. My dealer was good to replace it with a new one right away but am a little afraid that this may happen again. |
|
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Sat Sep 23, 2017 4:44 pm
|
|
|
Joined: 16 Jul 2015
Posts: 2126
Location: Hudson,Wy
|
|
Well if anyone has an urge for a custom stock, this certainly qualifies as an excuse! Silver lining in that cloud... |
_________________ Only catch snowflakes on your tongue AFTER the birds fly south for the winter... |
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Sat Sep 23, 2017 5:52 pm
|
|
|
Member
![Member Member](images/theavatar.jpg)
Joined: 09 Dec 2009
Posts: 1370
Location: Cheyenne, Wy
|
|
Don't quite understand why folks are doing their best to run out and buy one of these guns with so many problems being reported?
Just to say you have a "New Sweet 16?"
Dale |
_________________ One man with courage makes a majority.
...Andrew Jackson... |
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Mon Sep 25, 2017 7:01 am
|
|
|
Joined: 13 Jul 2017
Posts: 39
|
|
25 Sept. 16
I wonder if they've done some redesign on the fore end? I ordered mine early in they year and got it in May. I'd heard about the fore end problems. They had a notice in the manual about instillation of the fore end so I suspect they were aware of the problem.
Mine has been through about 1000 rds over the summer and no problems with the fore end cracking. I even got luck with the trigger breaking well below the weight of the gun.
I got lucky and got a good one (I hope). Once upon a time you didn't have to be lucky. If it said Browning, Winchester, Remington on the gun, it worked and nothing broke. I fear quality control has gone the way of the dodo.
Bill |
|
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Mon Sep 25, 2017 7:17 am
|
|
|
Member
![Member Member](images/theavatar.jpg)
Joined: 22 Aug 2011
Posts: 1498
Location: the Moosehorn
|
|
I have held off on getting one of these. I think that for $1500.00 luck should not play a part in the decision to buy one. I have read that the 12ga version also has some chronic jamming problems and they kick uncomfortably hard. |
_________________ ALWAYS wear the safety glasses
If you take Cranberries and stew them like applesauce they taste much more like Prunes than Rhubarb does ----G.M/ |
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Mon Sep 25, 2017 1:33 pm
|
|
|
Joined: 13 Jul 2017
Posts: 39
|
|
25 Sept. 17
You can't beat physics. The gun weighs 5.75 lbs. With heavy loads, recoil will be noticeable. I don't believe I've shot anything heavier than 1 oz at about 1250 fps and recoil was manageable. In fact it was less than I expected. However when I go over to 1 1/8 heavy loads for birds this fall, I expect to feel it. I would not recommend the gun for targets with anything over an ounce. With my 7/8 oz hand loads, its quite mild.
As to jamming, only with Herters shells. Federal, Winchester and Remington all run flawlessly. Once I reload the Herter's hulls, they also run 100%.
Still a pity that you even have to think of such things before making a purchase.
Bill |
|
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Mon Sep 25, 2017 1:38 pm
|
|
|
Joined: 19 Apr 2008
Posts: 477
|
|
its just bad karma. It isn't an A5 or a Sweet 16. Just shallow pretenders. The gods have looked down upon them and frowned and they will always be cursed. |
_________________ Many places remain undiscovered. Some because no one has ever been there. Others because no one has ever come back. |
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|
Posted:
Mon Sep 25, 2017 4:15 pm
|
|
|
Joined: 17 Mar 2017
Posts: 2800
Location: Endless Mountains of Pa
|
|
Gentlemen,
Having owned a real nice Browning 28/20 Combo gun for many years that I never had any trouble with, my opinion of Browning Shotguns is that they make a nice quality shotgun. In fact my brother owns a grade V 12 Gauge and a real nice 28 also. Never a problem with his guns, and he did a heck of a lot of shooting At Nemacoiln down thru the years. A company that produces as many shotguns as Browning is going to have some stock grain trouble and other problems down thru the years. As long as Browning corrects the problems, you keep purchasing from the company.
Pine Creek/Dave
My Cased Browning 28/20 Combo Gun - Never had a single problem with it.
[URL=http://www.jpgbox.com/page/52556_600x400/]
[/URL] |
_________________ "L.C. Smith America's Best" - John Houchins
Pine Creek Grouse Dog Trainers |
|
|
|
|
![](templates/NoseBleed/images/spacer.gif) |
|