Author |
Message |
< 16ga. General Discussion ~ Pierced Primer Repair |
|
Posted:
Thu Nov 16, 2017 5:53 pm
|
|
|
Joined: 15 Dec 2016
Posts: 36
Location: Down East Maine
|
|
Test fired my new-to-me Kreighoff drilling today and experienced a pierced primer with the left barrel. Had previously fired some 2.5" vintager shot loads without incident, but today tried some 2.5" Brenneke slugs to see where they printed. Noted the pierced primer at once, of course, upon opening the gun.
Inspection with a magnifying glass showed the left firing pin tip to look a bit eroded, amd the firing pin hole perhaps a bit enlarged. Seems odd that this has developed on the left barrel before the right, as most doubles seem to have the right barrel used much more than the left. Go figure.
Anyway, would appreciate recomendations on who to send it to for correction. Cole Gunsmithing here in Maine comes to mind. Other recommendations welcomed.
Thanks in advance for any suggestions. |
_________________ L.C. Smith FW Field Grade 16 IC/M
L.C. Smith FW Ideal Grade 16 M/F
Fox Sterlingworth 16 M/F
Ithaca M37 16
Krieghof Sempert Drilling 16x16/8x57
1925 Browning A5 16 CYL |
|
|
|
|
|
|
Posted:
Fri Nov 17, 2017 10:16 am
|
|
|
Member
Joined: 22 Aug 2011
Posts: 1498
Location: the Moosehorn
|
|
do you want a new pin installed or the old pin fixed ? |
_________________ ALWAYS wear the safety glasses
If you take Cranberries and stew them like applesauce they taste much more like Prunes than Rhubarb does ----G.M/ |
|
|
|
|
|
|
Posted:
Fri Nov 17, 2017 11:43 am
|
|
|
Joined: 15 Dec 2016
Posts: 36
Location: Down East Maine
|
|
byrdog wrote: |
do you want a new pin installed or the old pin fixed ?
|
Thanks for getting back to me.
Whichever is the more appropriate repair. If the pin hole is in fact eroded that might have to be bushed in some fashion, or perhaps a slightly larger pin installed. If fixing the original pin will suffice, fine. Avoiding gas blow-by into the lockwork is the ultimate concern. |
_________________ L.C. Smith FW Field Grade 16 IC/M
L.C. Smith FW Ideal Grade 16 M/F
Fox Sterlingworth 16 M/F
Ithaca M37 16
Krieghof Sempert Drilling 16x16/8x57
1925 Browning A5 16 CYL |
|
|
|
|
|
|
Posted:
Mon Nov 20, 2017 7:48 pm
|
|
|
Joined: 15 Jun 2010
Posts: 1358
Location: Twin Cities, MN
|
|
On most of these older German guns the firing pin is integral to the hammer, so having someone weld up and reshape the firing pin is much less expensive. When I broke the hammer/firing pin on my Simson I had a ‘smith pin it back together. Having a new one machined and fit is difficult, expensive and hard to find someone who can do it. I would talk to New England Custom Guns. They are relatively close to you.
https://www.newenglandcustomgun.com
Regards,
Jeff |
|
|
|
|
|
|
|